RESEARCH OF THE DEFORMATION ZONE ON STEPWISE MOLDING PRESS IN CONDITIONS OF JSC “CHEREPOVETS PIPE-ROLLING PLANT”
https://doi.org/10.17073/0368-0797-2014-3-49-52
Abstract
The authors developed the calculation method, which allows to determine the relation between the contact and non-contact areas for the deformation zone on stepwise molding press (FFS). Experimentally tested ratio of straight and curved sections of proximity zones of deformation. Two variants of histograms describe the results of calculation for the double radial circuits and profile with three radiuses blank in the outbreak strain with the permissible amount of reduction.
About the Authors
S. V. Samusev
National University of Science and Technology "MISIS" (MISIS) (Moscow, Russia)
Russian Federation
Dr.Eng., Professor
Russian Federation
Dr.Eng., Professor
A. V. Ljuskin
National University of Science and Technology "MISIS" (MISIS) (Moscow, Russia)
Russian Federation
Postgraduate
Russian Federation
Postgraduate
A. I. Romancov
JSC “Chelyabinsk pipe-rolling plant” (Chelyabinsk, Russia)
Russian Federation
Deputy Head of worksho
Russian Federation
Deputy Head of worksho
K. L. Zhigunov
JSC “Chelyabinsk pipe-rolling plant” (Chelyabinsk, Russia)
Russian Federation
Head of Technology Bureau
Russian Federation
Head of Technology Bureau
A. N. Fortunatov
Vyksa branch of the National University of Science and Technology “MISIS” (Vyksa, Nignij Novgorod region, Russia)
Russian Federation
Russian Federation
Assist. professor
References
1. Samusev S.V., Ljuskin A.V., Bol’dt V.V. Izv. Vuz. Chernaja metallurgija. 2010. №3. pp. 9 – 13.
2. Kolikov A.P., Romanenko V.P. etc. Mashiny i agregaty trubnogo proizvodstva: ucheb. posob (Machines and equipment for pipe production: study allowance). Moscow: MISiS, 1998. 536 p.
3. Samusev S.V., Velichko A.A., Ljuskin A.V., Andre-e v Ju.P., Voroncov A.N. Izv. Vuz. Chernaja metallurgija. 2009. №5. pp. 36 – 40.
4. Danchenko V.N., Kolikov A.P., Romancev B.A. Tehnologija trubnogo proizvodstva: uchebnik dlja vuzov (Pipe production technology: a textbook for universities). Moscow: Intermet Inzhiniring, 2002. 640 p.
5. Samusev S.V., Ljuskin A.V. Izv. vuzov. Chernaja metallurgija. 2009. № 1. pp. 10 – 12.
6.
Review
For citations:
Samusev S.V., Ljuskin A.V., Romancov A.I., Zhigunov K.L., Fortunatov A.N. RESEARCH OF THE DEFORMATION ZONE ON STEPWISE MOLDING PRESS IN CONDITIONS OF JSC “CHEREPOVETS PIPE-ROLLING PLANT”. Izvestiya. Ferrous Metallurgy. 2014;57(3):49-52. (In Russ.) https://doi.org/10.17073/0368-0797-2014-3-49-52
Views:
741
Email this article 