DETERMINATION OF THE RELATIVE STRENGTH OF SOLID FUELWITH DIFFERENT RATIOS OF COKE AND ANTHRACITE FUEL BEDIN SHAFT FURNACES
https://doi.org/10.17073/0368-0797-2014-12-37-39
Abstract
The paper presents estimated data on the relative strength of the solid fuel for various ratios of coke and anthracite coal in the fuel bed charge when carrying out tests on the facility for determination the solid fuel strength by the developed technique. The optimal experimentally reasonable value content of anthracite and coke in the fuel bed charge (60 % and 40 %, consequently, while relative strength of 0.85) is recommended.
About the Authors
A. V. Feoktistov
Siberian State Industrial University (42, Kirova str., Novokuznetsk, Kemerovo Region, 654007, Russia)
Russian Federation
Cand. Sci.(Eng.), Assist.Professor
Russian Federation
Cand. Sci.(Eng.), Assist.Professor
O. G. Modzelevskaya
Siberian State Industrial University (42, Kirova str., Novokuznetsk, Kemerovo Region, 654007, Russia)
Russian Federation
Senior Lecturer
Russian Federation
Senior Lecturer
S. A. Bedarev
Siberian State Industrial University (42, Kirova str., Novokuznetsk, Kemerovo Region, 654007, Russia)
Russian Federation
Cand. Sci. (Eng.), Assist.Professor
Russian Federation
Cand. Sci. (Eng.), Assist.Professor
References
1. Selyanin I.F., Feoktistov A.V., Filinberg I.N., Podolikov Ya.K., Prokhorenko A.V. Facility for the solid fuel strength analysis used in shaft furnaces. Izvestiya VUZov. Chernaya metallurgiya = Izvestiya – Ferrous Metallurgy. 2012, no. 6, pp. 23–26. (In Russ.).
2. Selyanin I.F., Feoktistov A.V., Bedarev S.A. Facility and technique of the solid fuel strength performances analysis. Liteinoe proizvodst-
3. Spravochnik po chugunnomu lit’yu [Iron casting. Reference book]. Girshovich N.G. ed. Leningrad: Mashinostroenie, 1978. 758 р. (In Russ.).
4.
Review
For citations:
Feoktistov A.V., Modzelevskaya O.G., Bedarev S.A. DETERMINATION OF THE RELATIVE STRENGTH OF SOLID FUELWITH DIFFERENT RATIOS OF COKE AND ANTHRACITE FUEL BEDIN SHAFT FURNACES. Izvestiya. Ferrous Metallurgy. 2014;57(12):37-39. (In Russ.) https://doi.org/10.17073/0368-0797-2014-12-37-39
Views:
607
Email this article 