STUDY OF DISTORTION OF CROSS-SECTION CONTINUOUSLY CAST SLABS
https://doi.org/10.17073/0368-0797-2014-1-34-37
Abstract
On the surface of the slab cross-section 270×1200 mm revealed the presence of bulge narrow faces and tightening wide faces in edge zone at JSC “Ural Steel”. The effect of the length of the supporting system of narrow faces blank on the parameters of distortion of the profi le of the slab was viewed. A statistically significant correlation between the parameters of profi le distortion of the workpiece was established. The deformation mechanism of the workpiece in the limited action of the supporting system below the mold was proposed. Measures to prevent distortion of the profile of the cast slab were considered.
About the Authors
E. A. Shevchenko
Magnitogorsk state technical university named after G.I. Nosov (Magnitogorsk, Russia
Russian Federation
Russian Federation
A. M. Stolyarov
Magnitogorsk state technical university named after G.I. Nosov (Magnitogorsk, Russia)
Russian Federation
Russian Federation
A. N. Shapovalov
Novotroitsk branch of the National University of Science and Technology “MISIS”
Russian Federation
Russian Federation
K. V. Baranchikov
JSC “Ural Steel”
Russian Federation
Russian Federation
References
1. Шевченко Е.А., Столяров А.М., Шаповалов А.Н. // Вестник МГТУ им. Г.И. Носова. 2013. № 1 (41). С. 27 – 30.
2. Шевченко Е.А., Столяров А.М., Шаповалов А.Н. // Наука и производство Урала: Межрегион. сб. научн. тр. – Новотроицк: НФ НИТУ «МИСиС», 2013. Вып. 9. С. 57 – 61.
3. Шевченко Е.А., Столяров А.М., Шаповалов А.Н. // Теория и технология металлургического производства: Межрегион. сб. науч. тр. – Магнитогорск: МГТУ им. Г.И. Носова, 2012. Вып. 12. С. 68 – 74.
4. Шевченко Е.А., Столяров А.М., Шаповалов А.Н. // Машиностроение: сетевой электронный научный журнал. 2013. № 1. С. 38 – 41.
5. Шевченко Е.А., Столяров А.М., Шаповалов А.Н. // Достижения и перспективы естественных и технических наук: Сб. науч. тр. II Междунар. научно-практич. конф. – Ставрополь: Логос, 2012. С. 90 – 95.
6. Шевченко Е.А., Столяров А.М., Шаповалов А.Н. // Технические науки – основа современной инновационной системы: Сб. науч. тр. II Междунар. научно-практич. конф. – Йошкар-Ола: Коллоквиум, 2013. С. 102 – 105.
Review
For citations:
Shevchenko E.A., Stolyarov A.M., Shapovalov A.N., Baranchikov K.V. STUDY OF DISTORTION OF CROSS-SECTION CONTINUOUSLY CAST SLABS. Izvestiya. Ferrous Metallurgy. 2014;57(1):34-37. (In Russ.) https://doi.org/10.17073/0368-0797-2014-1-34-37
Views:
637
Email this article 