THE RESEARCH OF DEFECTS – STRESS CONCENTRATORS BY THE ACOUSTIC EMISSION PARAMETERS AT THE PROCESS OF DAMAGE DEVELOPMENT
https://doi.org/10.17073/0368-0797-2015-12-912-918
Abstract
The paper presents the results of the theoretical and experimental investigation of the influence of stress concentrators on the damaging of titanium alloys. The samples of ОТ4 (α-class) and VТ3-1 (α + β-class) titanium alloys with different radii of stress concentrators have been researched. It has been also estimated the influence of stress concentration on the parameters of acoustic emission when using the samples of different radii. In the article the authors have described the graphic dependence of the material volume, getting involved into the deformation, on the distribution of maximum local stresses and the distribution diagram of the main AE parameters for the samples with different radii of stress concentrators from ОТ4 and VTЗ-1 alloys in dependence on the nominal failing stress. The results of the theoretical and experimental investigation of the influence of stress concentrators α on the damaging of ОТ4 and VT3-1 titanium alloy have been given. The research results can be used for the development of construction-diagnostic technique on the point of view of the identification of a less dangerous form of stress concentrator.
About the Authors
O. V. Bashkov
Komsomolsk-na-Amure State Technical University
Russian Federation
Russian Federation
Dr. Sci. (Eng.), Professor, Head of Centre of Collective Use “New Materials and Technologies”,
27, Lenina ave., Khabarovsk Territory, Komsomolsk-on-Amur, 681013
V. I. Murav’ev
Komsomolsk-na-Amure State Technical University
Russian Federation
Russian Federation
Dr. Sci. (Eng.), Professor of the Chair “Mechanical Engineering and Metallurgy”, Chief Research Consultant,
27, Lenina ave., Khabarovsk Territory, Komsomolsk-on-Amur, 681013
S. Z. Lonchakov
Komsomolsk-na-Amure State Technical University
Russian Federation
Russian Federation
Cand. Sci. (Eng.), Senior Researcher, Head of the Laboratory of Spectral Analysis,
27, Lenina ave., Khabarovsk Territory, Komsomolsk-on-Amur, 681013
A. V. Frolov
Komsomolsk-na-Amure State Technical University
Russian Federation
Russian Federation
Cand. Sci. (Eng.), Doctoral,
27, Lenina ave., Khabarovsk Territory, Komsomolsk-on-Amur, 681013
References
1. Semashko N.A., Filonenko S.F., Mokritskaya E.B., Belikov O.V. Forecasting of the limiting state in the concept of material microplastic deformation. In: Prikladnye zadachi mekhaniki deformiruemogo tverdogo tela i progressivnye tekhnologii v mashinostroenii. Sb. nauchnykh trudov [Applied problems of the mechanics of deformable solids and progressive technologies in machine-building. Collected scientific papers]. Vladivostok: Dal’nauka, 1997, pp. 148–153. (In Russ.).
2. Callins Jack A. Failure of materials in mecnanical desighn. Analysis, Prediction, Prevention. New Jork etc, John Wiley & Sons, 1981. (Russ.ed.: Callins J.A. Povrezhdenie materialov v konstruktsiyakh. Analiz. Predskazanie. Predotvrashchenie. Moscow: Mir, 1983, 615 p.).
3. Filonenko S.F. Akusticheskaya emissiya [Acoustic emission]. Kiev, 1999, 304 p. (In Russ.).
4. Semashko N.A., Murav’ev V.I., Bashkov O.V., Frolov A.V. Prognostication of the limiting condition of ОТ4 alloy with the use of acoustic emission method. Kontrol’. Diagnostika. 2001, no. 6, pp. 30–31. (In Russ.).
5. Semashko N.A., Frolov A.V., Murav’ev V.I., Lyakhovitskii M.M. Use of new acoustic emission parameters for the prognostication of the limiting mechanical characteristics of ОТ4 titanium alloy. Kontrol’. Diagnostika. 2002, no. 12, pp. 24–27. (In Russ.).
6. Semashko N.A., Murav’ev V.I., Frolov A.V., Krupskii R.F. Acoustic emission in a research practice of plastic deformation and material fracture. Materialovedenie. 2004, no. 7, Spec. Issue, pp. 36–40. (In Russ.).
7. Murav’ev V.I., Frolov A.V., Dmitriev E.A., Bashkov O.V., Tarasov E.A. Testing of phase transformation effi ciency in technological operations of structure production from steel and alloys using the method of acoustic emission. Uchenye zapiski Komsomol’skogona-Amure Gosudarstvennogo tekhnicheskogo universiteta. 2011, no. III-1 (7), pp. 91–100. (In Russ.).
8. Semashko N.A., Murav’ev V.I., Frolov A.V., Fizulakov R.A. Acoustic emission at the resolution of the issues of avation. Aviatsionnaya promyshlennost’. 2004, no. 2, pp. 85–89. (In Russ.).
9. Grin R.E. Characteristics of AE sources for the estimation of construction strength. In: AE v diagnostike predrazrushayushchego sostoyaniya i prognozirovaniya razrusheniya svarnykh konstruktsii: Dokl. I Mezhdunarodnoi shkoly stran – chlenov SEV [AE in the diag nostic of a predestructive state and forecasting of welded structure damagings: Report I of the International school of member countries CMEA]. Moscow: 1986, pp. 26–36. (In Russ.).
10. Kuranov V.N., Ivanov V.I., Ryabov A.N. Сharacteristics of the amplitude distribution of acoustic emission in the nucleation and propagation of fatigue cracks. The Soviet journal of nondestructive testing. 1982, vol. 18, no. 5, pp. 362–365.
11. Lyakhovitskii M.M., Roshchupkin V.V., Minina N.A., Pokrasin M.A., Krupskii R.F. Research of structural evolution kinetics and transformation in VТ23 titanium alloy by acoustic and dilatometric methods. In: Ul’trazvuk i termodinamicheskie svoistva veshchestva. Vyp. 6 [Ultrasound and thermodynamic properties of substances. Issue 6]. Kursk: izd. Kurskogo gos. un-ta, 2009, pp. 8–17. (In Russ.).
12. Khrutskii O.V., Yuras S.F. Akustiko-emissionnyi metod diagnostirovaniya sudovykh energeticheskikh ustanovok. Uchebnoe posobie [Acoustic-emission diagnostic technique of ship power installation. Instructional aid]. Leningrad, 1985, 47 p. (In Russ.).
13. Ivanov V.I., Bykov V.P. Classifi cation of acoustic emission sources. Diagnostika i prognozirovanie razrusheniya svarnykh konstruktsii. 1985, no. 1, pp. 67–74. (In Russ.).
14. Miklyaev P.G., Neshpor G.S., Kudryashov V.G. Kinetika razrusheniya [Fracture kinetics]. Moscow: Metallurgiya, 1979, 279 p. (In Russ.).
15. Fesik S.P. Spravochnik po soprotivleniyu materialov [Reference book on strength of materials]. Kiev: Budyvel’nik, 1982, 280 p. (In Russ.).
Review
For citations:
Bashkov O.V., Murav’ev V.I., Lonchakov S.Z., Frolov A.V. THE RESEARCH OF DEFECTS – STRESS CONCENTRATORS BY THE ACOUSTIC EMISSION PARAMETERS AT THE PROCESS OF DAMAGE DEVELOPMENT. Izvestiya. Ferrous Metallurgy. 2015;58(12):912-918. (In Russ.) https://doi.org/10.17073/0368-0797-2015-12-912-918
Views:
757
Email this article 