THE DETERMINATION OF CUTTING FORCE ON THE SCISSORS AT PRE-CURVED STRIP CUTTING
https://doi.org/10.17073/0368-0797-2015-5-386-387
Abstract
The method of calculation of the cutting force on the scissors at pre-curved strip cutting has been offered. It was determined that at maximum cutting force of pre-cutting curved strip is less than at cutting of the straight one.
About the Authors
A. G. Nikitin
Siberian State Industrial University 42, Kirova str., Novokuznetsk, Kemerovo Region, 654007, Russia
Russian Federation
Russian Federation
Dr. Sci. (Eng.), Assist. Professor of the Chair “Transport and Logistics”
J. A. Epifanctev
Siberian State Industrial University 42, Kirova str., Novokuznetsk, Kemerovo Region, 654007, Russia
Russian Federation
Russian Federation
Cand. Sci. (Eng.), Assist. Professor of the Chair “Technical mechanics and graphics”
E. I. Demina
Siberian State Industrial University 42, Kirova str., Novokuznetsk, Kemerovo Region, 654007, Russia
Russian Federation
Russian Federation
Postgraduate of the Chair “Transport and Logistics”
References
1. Mashiny i agregaty metallurgicheskikh zavodov [Machines and equipment for steel plants]. Tselikov A.I. ed. Vol. 3. Moscow: Metallurgiya. 1988. 680 p. (In Russ.).
2. Nikitin A.G., Belov E.G., Poltоratskii L.M. Ustroistvo dlya rezki prokata [A device for cutting of rolled products]. Patent RF no. 91911, Byulleten’ izobretenii. 2010, no. 7. (In Russ.).
3. Belyaev N.M. Soprotivlenie materialov [strength of materials]. Moscow: Nauka. 1965. 312 p. (In Russ.).
Review
For citations:
Nikitin A.G., Epifanctev J.A., Demina E.I. THE DETERMINATION OF CUTTING FORCE ON THE SCISSORS AT PRE-CURVED STRIP CUTTING. Izvestiya. Ferrous Metallurgy. 2015;58(5):386-387. (In Russ.) https://doi.org/10.17073/0368-0797-2015-5-386-387
Views:
631
Email this article 