Preview

Izvestiya. Ferrous Metallurgy

Advanced search

CHANGES IN STRUCTURE AND PHASE COMPOSITION OF THE SURFACE OF DIFFERENTIALLY HARDENED 100-METER RAILS IN OPERATION

https://doi.org/10.17073/0368-0797-2017-10-826-830

Abstract

By the methods of optical and transmission electron diffraction microscopy the evolution of structural-phase states of the surface layers in the head of differentially hardened rails of category DT350 was studied to the depth up to 10 mm in the fillet after the passed tonnage of 691.8 million gross tones on the experimental ring of JSC “VNIIZhT”. It is shown that in the initial state the following structural constituents present in the rail head: grains of lamellar perlite (relative content is 0.7), grains of ferrite-carbide mixture (0.25) and grains of structurally free ferrite. After the passed tonnage of 691.8 million gross tones this state is preserved only at a depth of more than 10 mm. A distinctive feature of the structure at this distance is a large number of bending extinction contours, which reveals elastoplastic distortions of the crystal lattice in the material. Stress concentrators of the steel under study are intra- and interphase interfaces of grains of ferrite and perlite, cementite plates and ferrite of perlite colonies, globular cementite particles and ferrite. The transformation of the structure is manifested at the macro level in the formation of microcracks at an acute angle to the surface to a depth up to 140 μm, and in the formation of the decarburized layer. At the micro level, the formation of elastoplastic stress fields and the destruction of cementite plates of perlite colonies have been revealed. It is shown that stress concentrators are intra- and interphase interfaces of ferrite and perlite grains, cementite and ferrite plates of ferrite colonies, globular cementite particles and ferrite. In the grains of structurally free ferrite, the formation of nano-sized particles of cementite was observed. The comparison is made with the results of the evolution of structural-phase states in the fillet of volume-hardened rails after the passed tonnage of 500 million gross tones: the most significant transformations of structural-phase states are observed in the surface layers. The evolution of the structural-phase state of perlite of lamellar morphology consists in the dissolution of cementite plates, which leads to the formation of a chain of particles of the carbide phase with globular shape in place of the cementite plate. This is possible due to the transfer of carbon atoms from the crystalline lattice of cementite to dislocations.

About the Authors

A. A. Yur’ev
JSC “EVRAZ – Joint West Siberian Metallurgical Plant”
Russian Federation

Research Engineer of Department of Scientific Research,

Novokuznetsk



V. E. Gromov
Siberian State Industrial University
Russian Federation

Dr. Sci. (Phys.-math.), Professor, Head of the Chair of Science named after V.M. Finkel,

Novokuznetsk



K. V. Morozov
JSC “EVRAZ – Joint West Siberian Metallurgical Plant”
Russian Federation

Cand. Sci. (Eng.), Head of Rolling Production,

Novokuznetsk



O. A. Peregudov
Omsk State Technical University
Russian Federation

Assistant to the Rector for Youth Policy,

Omsk



References

1. Gromov V.E., Yuriev A.B., Morozov K.V., Ivanov Y.F. Microstructure of gradient rails. Carbide. CISP Ltd, 2016, 153 p.

2. Sheinman E. Wear of rails. J. of Friction and Wear. 2012, vol. 33, no. 4, pp. 308–314.

3. Ivanisenko Yu., Fecht H.J. Microstructure modification in the surface layers of railway rails and wheels. Steel Tech. 2008, vol. 3, no.  1, pp. 19–23.

4. Ivanisenko Yu., Maclaren, I., Sauvage, X., Valiev R.Z., Fecht H.-J. Shear-induced α → γ transformation in nanoscale Fe–C composite. Acta Mater. 2006, vol. 54, pp. 1659–1669.

5. Ning Jiang-Li, Courtois-Manara E., Kurmanaeva I., Ganeev A.V., Valiev R.Z., Kübel C., Ivanisenko Yu. Tensile properties and work hardening behaviors of ultrafine grained carbon steel and pure iron processed by warm high pressure torsion. Mater. Sci. Eng. A. 2013, vol. 581, pp. 8–15.

6. Gavriljuk V.G. Decomposition of cementite in pearlite steel due to plastic deformation. Mater. Sci. Eng. A. 2003, vol. 345, pp. 81–89.

7. Li Y.J., Chai P., Bochers C., Westerkamp S, Goto S, Raabe D, Kirchheim R: Atomic-scale mechanisms of deformation-induced cementite decomposition in pearlite. Acta Mater. 2011, vol. 59, pp.  3965–3977.

8. Gavriljuk V.G. Effect of interlamellar spacing on cementite dissolution during wire drawing of pearlitic steel wires. Scripta Mater. 2001, vol. 45, pp. 1469–1472.

9. Hirsch P.B., Howie A., Nicholson R., Pashley D.W., Whelan M.J. The electron microscopy of thin crystals. Butterworths, 1965, 549  p. (Russ.ed.: Hirsh P., Hovi R., Nicholson R. Elektronnaya mikroskopiya tonkikh kristallov. Moscow: Mir, 1968, 574 p.).

10. Brandon David G., Kaplan Wayne D. Microstructural characterization of materials. Chichester, New York, 1999. (Russ.ed.: Brandon  D., Kaplan W. Mikrostruktura materialov. Metody issledovaniya i kontrolya. Moscow: Tekhnosfera, 2006, 384 p.).

11. Utevskii L.M. Difraktsionnaya elektronnaya mikroskopiya v metallovedenii [Diffraction electron microscopy in metallurgy]. Moscow: Metallurgiya, 1973, 584 p. (In Russ.).

12. Tomas Gareth, Goringe Michael J. Transmission electron microscopy of materials. New York-Chichester-Brisbane-Toronto, John Wiley Sons, 1979, 320 p. (Russ.ed.: Tomas G., Goringe M. Prosvechivayushchaya elektronnaya mikroskopiya materialov. Moscow: Nauka, 1983, 320 p.).

13. Ray F. Egerton. Physical principles of electron microscopy. An introduction to TEM, SEM, and AEM. Berlin: Springer Science+Business Media, Inc, 2005, 211 p.

14. The transmission electron microscope. Khan Maaz ed. ITAvE, 2016, 391 p.

15. C. Barry Carter, David B. Transmission electron microscopy. Berlin: Springer International Publishing, 2016, 518 p.

16. Panin V.E., Likhachev V.A., Grinyaev Yu.V. Strukturnye urovni deformatsii tverdykh tel [Structural levels of solids deformation]. Novosibirsk: Nauka, 1985, 229 p. (In Russ.).

17. Gromov V.E., Peregudov O.A., Ivanov Yu.F., Morozov K.V., Alsaraeva K.V., Semina O.A. Surface layer structure degradation of rails in prolonged operation. Journal of surface investigation. X-ray, synchrotron and neutron techniques. 2015, vol. 9, no. 6, pp.  1292–1298.

18. Gromov V.E., Ivanov Yu.F., Peregudov O.A., Morozov K.V., Wang  X.L., Dai W.B., Ponomareva Yu.V., Semina O.A. Evolution of structure and properties of railhead fillet in long-term operation. Materials and Electronics Engineering. 2015, vol. 2, no. 4, pp. 1–4.

19. Gromov V.E., Ivanov Y.F., Morozov K.V., Peregudov O.A., Semina  O.A. Long-term operation of rail steel: degradation of structure and properties of surface layer. Journal of surface investigation. X-ray, Synchrotron and Neytron techniques. 2016, vol. 10, no. 5, pp.  1101–1105.

20. Ivanov Y.F., Morozov K.V., Peregudov O.A., Gromov V.E. Degradation of rail-steel structure and properties of the surface layer. Steel in Translation. 2016, vol. 46, no. 8, pp. 567–570.


Review

For citations:


Yur’ev A.A., Gromov V.E., Morozov K.V., Peregudov O.A. CHANGES IN STRUCTURE AND PHASE COMPOSITION OF THE SURFACE OF DIFFERENTIALLY HARDENED 100-METER RAILS IN OPERATION. Izvestiya. Ferrous Metallurgy. 2017;60(10):826-830. (In Russ.) https://doi.org/10.17073/0368-0797-2017-10-826-830

Views: 633


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 0368-0797 (Print)
ISSN 2410-2091 (Online)